Quilters Select Print & Piece Fuse Lite - 25 Sheets - 8.5" x 11"

Directions for general sse as a stabilizer for embellishment:

• Heat iron to silk setting (low).
• Position the fusible side of Print & Piece Fuse Lite over the wrong side of the fabric.
• Cover the stabilizer with a cotton pressing cloth or piece of muslin. It is also OK to press from the fabric side instead of the stabilizer side.*
• Press with the iron with an up-and-down motion, not side-to-side. If a bond is not achieved, slightly increase your iron temperature and try again.**
• Once stitching is complete, slightly dampen the stitching line and pull away the stabilizer.

*Remember that all irons heat differently. We recommend testing on scrap fabric before beginning your project.

**The fusible coating on the stabilizer was designed to be temporary. If the iron temperature used is too hot, the bond may become permanent.

Directions for needle turn appliqué:

• Print or trace the image on to the non-fusible side of the stabilizer.
• Trim away the excess stabilizer by cutting directly on the lines.
• Fuse the stabilizer/image onto the wrong side of the fabric being used for the appliqué.
• Trim the fabric to within a generous ¼ of the stabilizer/ image.
• Use a fabric-safe glue stick and lightly coat the edge of the stabilizer/image.
• Turn the fabric so that it sticks to the glue.
• The appliqué is now ready to be stitched into place on your quilt block, garment or home dec project!
• There is no need to remove the stabilizer from behind the appliqué: when washed, half of the fibers will dissipate; the other fibers will create a slight loft under the appliqué.